High Beam Indicator Inoperative

Possible Causes are:

• INSTRUMENT CLUSTER

Ensure that the Exterior High Beam Headlamps operate properly before proceeding with this test. Ensure that there is communication between the Instrument Cluster and the BCM before proceeding with this test. Perform the Instrument Cluster Self Test. The self test can be performed with the DRBIII(R), or manually using the following procedure: Turn ignition off. Press and hold the Trip Reset button. Turn ignition on. Observe the High Beam indicator during the Self Test. Did the High Beam indicator illuminate for approximately 4 seconds and then turn off? If yes, test is complete. If no, replace the instrument cluster. Perform BODY VERIFICATION TEST VER 1  under VERIFICATION TESTS.