LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2002 >> Wrangler X, Automatic >> Repair and Diagnosis >> Suspension >> Wheel Alignment Specifications & Adjustment Procedures >> Wheel Alignment Procedures >> Toe-In Adjustment
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Toe-In Adjustment

NOTE: If vehicle is equipped with power steering, engine must be running during entire toe-in adjustment procedure.
  1. If vehicle is equipped with power steering, start engine. Turn wheels both ways before straightening steering wheel. Center and secure steering wheel in straight-ahead position. Measure toe-in and compare to specification. See ALIGNMENT SPECIFICATIONS  .
  2. Loosen drag link adjustment sleeve clamp bolts. See Fig 1 . Rotate adjustment sleeve to adjust right wheel toe to specification. See ALIGNMENT SPECIFICATIONS  . Position clamp bolts so threaded bolt ends face as shown. See Fig 1 . Tighten drag link adjustment sleeve clamp bolts to specification. See TORQUE SPECIFICATIONS  .
  3. Loosen tie rod adjustment sleeve clamp bolts at each end of tie rod. See Fig 1 . Rotate adjustment sleeve to adjust left wheel to toe specification. See ALIGNMENT SPECIFICATIONS  . When adjustment is complete, position clamp bolts so threaded bolt ends face as shown, and tighten bolts to specification. See Fig 1 . See TORQUE SPECIFICATIONS  . Ensure toe setting does not change when tightening clamp bolts.
Fig 1: Locating Drag Link & Tie Rod Adjustment Sleeve Clamps
G96C25488Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals