Rear Power Outlet: Installation
- Align the splines on the outside of the rear power outlet receptacle base connector receptacle with the grooves on the inside of the mount.
- Insert the rear power outlet receptacle base about half way through the mount.
- Reconnect the right body wire harness connector to the rear power outlet receptacle base connector receptacle.
- Insert the rear power outlet receptacle base and mount into the right quarter trim panel as a unit until the mount is seated flush against the trim panel.
- Press firmly on the rear power outlet receptacle base until the retaining bosses of the mount are fully engaged in their receptacles.
- Install the protective cap into the rear power outlet receptacle base.
- Reconnect the battery negative cable.