Driver Rear Window Inoperative From Rear Switch
WARNING: This page is about a different car, the 2002 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Possible Causes
- OPEN GROUND CIRCUIT
- SWITCH DEFECTIVE
NOTE:
Ensure the Window Lock out Switch on the DDM is operating properly before proceeding.
Remove the Rear Door Trim Panel. Disconnect the Power Window Switch connector. Measure the resistance of the Ground circuit to ground. Is the resistance less than 5 ohms? If yes, replace the Power Window Switch. Perform BODY VERIFICATION TEST VER 1 under VERIFICATION TESTS. If no, repair the open ground circuit. Perform BODY VERIFICATION TEST VER 1 under VERIFICATION TESTS.