Clutch Switch: Testing and Inspection

DIAGNOSIS AND TESTING - CLUTCH PEDAL POSITION SWITCH
1. Locate switch 2-wire electrical connector under instrument panel (Fig. 12). Disconnect wiring at this point.
2. Check for switch continuity with an ohmmeter while operating clutch pedal up and down. Continuity should be broken and reapplied each time pedal is pressed.
3. If continuity is not present, or is always present at any pedal position, replace switch. Switch is not serviced separately. Replace clutch master cylinder.

REMOVAL
Switch is not serviced separately. If switch replacement is necessary, replace clutch master cylinder.

INSTALLATION
Switch is not serviced separately. If switch replacement is necessary, replace clutch master cylinder.