Installation - 4.0L

Slide throttle cable through hole in bracket until release tabs lock into bracket.
Connect cable ball end to throttle body bellcrank ball (snaps on).
Snap cable into routing clips on engine valve cover.
Slide rubber grommet away from plastic cable housing.
Install rubber grommet into dash panel until seated.
Push cable housing into rubber grommet and through opening in dash panel.
From inside vehicle, install clip holding cable to dash panel (Figure ).
From inside vehicle, slide throttle cable core wire into opening in top of pedal arm.
Push cable retainer (clip) into pedal arm opening until it snaps in place.
Before starting engine, operate accelerator pedal to check for any binding.