Self-Check Diagnostics

The EVIC is capable of performing a diagnostic self check on its internal functions. EVIC diagnostics may be performed using a DRBIII® or by using the following procedure:

1. With the ignition switch in the OFF position, depress and hold the RESET and the C/T buttons.
2. Turn the ignition switch to the ON position.
3. Continue to hold both buttons until the software versions are displayed, then release the buttons.
4. When the self-check is complete the EVIC will display one of the following messages:
   • PASSED SELF TEST
   • FAILED SELF TEST
   • FAILED J1850 COMMUNICATION
5. To exit the self-check mode, depress the RESET button or cycle the ignition switch and the EVIC will return to normal operation.

If a Communication fault is displayed, refer to COMMUNICATION . If a FAILED SELF TEST is displayed, the EVIC must be replaced.