Controller Antilock Brake: Installation

WARNING: This page is about a different car, the 2004 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If the CAB is being replaced with a new CAB is must be reprogrammed with the use of a DRB III.

Install the CAB onto the HCU and tighten mounting bolts to 1.8 N.m (16 in. lbs.).
Install pump motor connector.
Install CAB harness connector and push down connector release.
Install air cleaner housing, (Refer to AIR CLEANER HOUSING ) OR (Refer to AIR CLEANER HOUSING ).
Install negative battery cable to the battery.