Installation - 4.7L
WARNING: This page is about a different car, the 2004 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
The MAP sensor is located on the front of the intake manifold (Figure ). An O-ring seals the sensor to the intake manifold.
- Clean MAP sensor mounting hole at intake manifold.
- Check MAP sensor O-ring seal for cuts or tears.
- Position sensor into manifold.
- Install MAP sensor mounting bolts (screws). Tighten screws to 3 N.m (25 in. lbs.) torque.
- Connect electrical connector.