Section 150 (Power Liftgate System): Hinge: Installation
WARNING: This page is about a different car, the 2004 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
It is not necessary to remove the liftgate to replace one or both hinges. The hinges can be replaced one at a time.
NOTE:
Use a suitable body sealer on the hinge to body mating surfaces prior to installation.
- Position the hinge on the roof panel and on the liftgate.
- Install and tighten hinge screws at roof panel to 28 N.m (21 ft. lbs.).
- Install hinge screws at liftgate and tighten to 28 N.m (21 ft. lbs.).
- Install the upper liftgate opening trim panel. (Refer to LIFTGATE OPENING UPPER TRIM )
- Check the liftgate for proper alignment and operation. (Refer to GAP AND FLUSH )
- Check for water leaks at hinge to body screws.