Section 150 (Power Liftgate System): Liftgate: Installation
WARNING: This page is about a different car, the 2004 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Position the liftgate on the vehicle and align the witness marks.
- Install the hinge screws at liftgate and tighten to 28 N.m (20 ft. lbs.).
- Connect the wire harnesses and the washer hose.
- Install the trim panel. (Refer to TRIM PANEL )
- Install the prop rods.
- Close the liftgate and check for proper latching and alignment. Adjust as necessary. (Refer to ADJUSTMENTS )