Controller Antilock Brake: Installation

WARNING: This page is about a different car, the 2005 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

Install CAB to the HCU. See Fig 1.
Install mounting bolts. Tighten to 2 N.m (16 in. lbs.).

Install the pump electrical connector to the CAB. See Fig 1.

Fig 1: CONTROLLER AND HCU

Courtesy of DAIMLERCHRYSLER CORP.

1 - CONTROLLER ANTILOCK BRAKE MODULE

2 - HYDRAULIC CONTROL UNIT (H.C.U)

3 - ELECTRICAL CONNECTOR

Install the wiring harness connector to the CAB and push down on the release to secure the connector.
Install negative battery cable to the battery.