Electronic Brake Control Module: Description and Operation

MODULE-ANTILOCK BRAKES

DESCRIPTION

NOTE: If the ABM module is replaced it must be initialized using the scan tool.




The Antilock Brake Module (ABM) (1) is mounted to the Hydraulic Control Unit (HCU) (2) and operates the ABS system.

OPERATION
The ABM voltage is supplied by the ignition switch in the RUN position. The ABM contains dual microprocessors. A logic block in each microprocessor receives identical sensor signals. These signals are processed and compared simultaneously. The ABM contains a self check program that illuminates the ABS warning light when a system fault is detected. Faults are stored in a diagnostic program memory and are accessible with the scan tool. ABS faults remain in memory until cleared, or until after the vehicle is started approximately 50 times. Stored faults are not erased if the battery is disconnected.