LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Audio System & Video System (Service Information)) >> Module - Antenna >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module - Antenna: Installation

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.
Fig 1: Identifying Antenna Module
GC0028970Courtesy of CHRYSLER LLC
  1. Connect antenna cable to antenna module.
  2. Connect battery power supply lead to antenna module.
  3. Position antenna module onto right side upper roof rail. Install and tighten mounting fasteners.
  4. Connect antenna module lead to the integral antenna.
  5. Install headliner.
scientia non olet · About LEMON Manuals