Fuel Injection - Gas: Sensor-Map: Installation: 3.7L/4.7L

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating MAP Sensor O-Ring - 3.7L/4.7L

Courtesy of CHRYSLER LLC

Clean MAP sensor mounting hole at intake manifold.
Check MAP sensor O-ring seal (2) for cuts or tears.

Fig 2: MAP Sensor Location - 3.7L/4.7L
Courtesy of CHRYSLER LLC
Position MAP sensor into manifold by sliding sensor over locating pin (6).
Install mounting bolt (8). Tighten to 3 N.m (25 in. lbs.) torque.
Connect electrical connector (2).