LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2006 >> Wrangler X, Automatic >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Front >> Track Bar >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Track Bar: Installation

  1. Install the track bar at axle tube bracket. Loosely install the retaining bolt and flag nut.
  2. It may be necessary to pry the axle assembly over to install the track bar at the frame rail. Install track bar at the frame rail bracket. Install the retaining nut on the stud.
  3. Tighten the ball stud nut to 81 N.m (60 ft. lbs.) and install a new cotter pin.
  4. Remove the supports and lower the vehicle.
  5. Tighten the bolt at the axle bracket to 47 N.m (40 ft. lbs.).
  6. Check alignment if a new track bar was installed. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals