Sensor-Engine Coolant Temp: Removal: Removal-Diesel

Fig 1: THERMOSTAT AND SENSOR

Courtesy of CHRYSLER LLC

1 - FUEL RAIL

2 - EGR VALVE

3 - POWER STEERING PUMP

4 - GENERATOR

5 - COOLANT TEMPERATURE SENSOR

6 - THERMOSTAT HOUSING

7 - FUEL RAIL PRESSURE SENSOR

1. Disconnect negative battery cable.
2. Remove engine cover. Refer to REMOVAL .
3. Partially drain coolant system below pressurized coolant recovery container. See STANDARD PROCEDURE .
4. Unplug coolant temperature sensor electrical connector.
   NOTE: Capture any residual coolant that may flow.
5. Remove coolant temperature sensor (5).