LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2007 >> Liberty Limited, 4WD, Part Time >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Electronic Control Modules >> Module-Antilock Brake >> Removal >> Antilock Brake Module (ABM)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Antilock Brake Module (ABM)

Fig 1: ABM Module
GC0056737Courtesy of CHRYSLER LLC
CAUTION: When removing ABM from HCU, be sure to completely separate the two components (approximately 38 mm (1.5 in.) before removing ABM. Otherwise, damage to the pressure sensor or Pump Motor connection may result requiring HCU replacement. Do not to touch the sensor terminals on the HCU side or the contact pads on the ABM side as this may result in contamination and issues in the future.
  1. Remove the negative battery cable from the battery.
  2. Pull up on the ABM harness connector release and remove connector.
  3. Remove the ABM module mounting screws (1) from the ABM unit.
scientia non olet · About LEMON Manuals