LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2007 >> Wrangler Rubicon, Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System >> Charging >> Pulley - Generator DECOUPLER >> Removal >> Generator DECOUPLER >> INA Decoupler
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

INA Decoupler

Fig 1: #8823 Tool & INA Decoupler
GC0026375Courtesy of CHRYSLER LLC
1 - INA DECOUPLER
2 - TOOL #8823 (VM.1048)
  1. Disconnect negative battery cable.
  2. Remove generator and accessory drive belt. Refer to Generator REMOVAL .
  3. Position Special Tool #8823 (VM.1048) (2) into decoupler (1).
    Fig 2: End Of Generator Shaft (Hex)
    GC0026373Courtesy of CHRYSLER LLC
    1 - GENERATOR SHAFT
    2 - HEX
  4. Determine if end of generator shaft is hex shaped (2) or.
    Fig 3: End Of Generator Shaft (Splined)
    GC0026374Courtesy of CHRYSLER LLC
    1 - GENERATOR SHAFT
    2 - SPLINES
  5. or is splined (2).
    Fig 4: Decoupler Removal (INA-Hex)
    GC0026376Courtesy of CHRYSLER LLC
    1 - DEEP 10 MM SOCKET
    2 - TOOL #8823 (VM.1048)
  6. If hex is used, insert a 10mm deep socket (1) into tool #8823 (VM.1048) (2).
    Fig 5: Decoupler Removal (INA-Splined)
    GC0026377Courtesy of CHRYSLER LLC
    1 - DRIVER
    2 - TOOL #8823 (VM.1048)
    3 - 17 MM WRENCH
  7. If splined, insert a 5/16" 6-point hex driver, or a 10mm 12-point triple square driver (1) into tool #8823 (VM.1048) (2).
  8. The generator shaft uses conventional right-hand threads to attach decoupler. To break decoupler loose from generator threads, rotate tools as shown
  9. After breaking loose with tools, unthread decoupler by hand from generator.
scientia non olet · About LEMON Manuals