Transmitter

TRANSMITTER





1. Carefully pull down the left rear edge of the headliner from the upper liftgate opening far enough to reach between the headliner and the roof panel to position the intrusion sensor transmitter (2) over the locating pins of the mounting bracket (4) on the headliner substrate.
2. Press the transmitter down until the two latch features (3) of the mounting bracket are fully engaged.
3. Reconnect the take out of the overhead wire harness (1) to the connector receptacle on the right side of the transmitter housing.
4. Reinstall the trim onto the left upper D-pillar. Installation.
5. Reinstall the trim onto the upper liftgate opening. . Liftgate Trim Panel - Installation




6. Position the bezel (1) over the transducer housing (2) of the intrusion sensor transmitter and press it straight onto the housing until it snaps into place against the headliner (3). Be certain to take the appropriate precautions not to soil or damage the headliner.
7. Reconnect the battery negative cable.