LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2009 >> Liberty 2WD V6-3.7L >> Repair and Diagnosis >> Heating and Air Conditioning >> Control Assembly >> Service and Repair >> A/C and Heater Control - Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

A/C and Heater Control - Removal






REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.






NOTE: MTC A/C-heater control shown. ATC control similar.

1. Disconnect and isolate the negative battery cable.
2. Remove the center bezel from the instrument panel and place it on a workbenchInstrument Panel Bezel - Removal.
3. Remove the four screws (1) that secure the A/C-heater control (2) to the instrument panel center bezel (3) and remove the control.

scientia non olet · About LEMON Manuals