LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2011 >> Liberty Renegade, Part Time >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Ignition System (Service Information) >> PLUG, Glow >> Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

PLUG, Glow: Installation: Installation

Fig 1: Glow Plugs & Wiring Harness
GC0082161Courtesy of CHRYSLER LLC
  1. Apply a small amount of clean diesel oil or motor oil to glow plug threads.
  2. Attach a flexible tool such as a rubber hose to install glow plug into cylinder head. Tighten each plug to 14 N.m (124 in. lbs.).
  3. Connect glow plug wiring harness (2) to all four glow plugs (1).
  4. Install fuel rail. Refer to RAIL, Fuel, Installation or RAIL, Fuel, Installation .
  5. On 4x4 models, install the front axle. Refer to Installation .
  6. Install the belly pan.
  7. Lower the vehicle.
  8. Install the bolt securing high pressure feed tube at intake manifold. Tighten bolt to 15 N.m (133 in. lbs.).
  9. Install the generator. Refer to GENERATOR, Installation .
  10. Install the battery.
  11. Connect the positive battery cable.
  12. Install the serpentine belt. Refer to BELT, Serpentine, Installation .
  13. Connect air tube from air control valve and securely tighten clamp.
  14. Install the engine silencer and securely tighten the four retainers.
  15. Install the engine cover.
  16. Connect negative battery cable.
scientia non olet · About LEMON Manuals