LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2011 >> Liberty Renegade, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Electronic Control Modules (Service Information)) >> MODULE, Compass >> Removal >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

MODULE, Compass: Removal: Removal

WARNING: This page is about a different car, the 2011 Jeep Patriot and 2011 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

Fig 1: Identifying Remote Compass Module (RCM), Instrument Panel, Screws & Electrical Connector
GC0098553Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the instrument panel top cover. Refer to COVER, Instrument Panel, Removal .
  3. Remove the screws (3) securing the Remote Compass Module (RCM) (1) to the instrument panel (2).
  4. Disconnect the electrical connector (4) and remove the RCM from the vehicle.
scientia non olet · About LEMON Manuals