Removal - Power Distribution Z-Case Fuse Array

Fig 1: Identifying Power Distribution Z-Case Fuse Array, Tabs & Nuts

Courtesy of CHRYSLER GROUP, LLC

For complete circuit diagrams, refer to SYSTEM WIRING DIAGRAMS . The wiring information includes wiring diagrams, proper wire and connector repair procedures, further details on wire harness routing and retention, as well as pin-out and location views for the various wire harness connectors, splices and grounds.

1. Disconnect and isolate the battery negative cable. 
2. Remove the cover from the Power Distribution Center (PDC).
3. Remove the nuts (2) from Z case fuse array and move the eyelet connectors off and away from the Z case fuse array.
4. Remove the nut (1) attaching the fuse array to the PDC.
5. Press on the tabs (3) on the side of the fuse array to separate the array from the PDC.
6. Lift the fuse array away from the PDC.