LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2014 >> Cherokee Sport, FWD >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Ignition System (Service Information) >> Switch, Ignition >> Removal >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Switch, Ignition: Removal: Removal

  1. Disconnect the and isolate the negative battery cable.
  2. Remove the dash end cap. Refer to CAP, INSTRUMENT PANEL END, REMOVAL .
  3. Remove the steering column opening cover.
  4. Remove the HVAC control head. Refer to CONTROL, A/C AND HEATER, REMOVAL .
  5. Remove the instrument cluster bezel. Refer to BEZEL, INSTRUMENT CLUSTER, REMOVAL .
  6. Disconnect the wire harness connector from the Ignition Node Module.
    Fig 1: Removing/Installing Switch Mounting Screws
    GC0121041Courtesy of CHRYSLER GROUP, LLC
  7. Remove 4 screws from the I/P holding the Ignition Node Module in place.
  8. Remove the Ignition Node Module from the backside of the I/P.
scientia non olet · About LEMON Manuals