LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2014 >> Wrangler Sport, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Cooling System) >> Engine >> Heater, Engine Block >> Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Heater, Engine Block: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Block Heater & Screw
GC0144482Courtesy of CHRYSLER GROUP, LLC
  1. Thoroughly clean core hole and heater seat.
  2. Insert heater (1) into the engine block.
  3. With heater seated, tighten center screw (2) securely to assure a positive seal.

    Connect power cord to heater.

    Fig 2: A/C Compressor & Mounting Bolts
    GC0153970Courtesy of CHRYSLER GROUP, LLC
  4. Position the A/C compressor (2) to the engine block. Tighten the bolts (1) to 28 N.m (21 ft. lbs.).
  5. Reconnect the A/C compressor (2) electrical connector.
    Fig 3: Drive Belt Tensioners & Assembly With Drive Belt
    GC0153982Courtesy of CHRYSLER GROUP, LLC
  6. Install the accessory drive belt.
    Fig 4: Air Cleaner Body, Fresh Air Makeup Hose, Electrical Connector, Clamp, Bolts & Retainers
    GC0154000Courtesy of CHRYSLER GROUP, LLC
  7. Install the air filter housing cover (1).
  8. Install the air intake support bolts (5).
  9. Install the air intake hose to the throttle body (4) and tighten the clamp.
  10. Reconnect the temperature sensor electrical sensor connector (3).
  11. Install the air breather tube (2).
  12. Reconnect the negative battery cable.
  13. Install the engine cover.
scientia non olet · About LEMON Manuals