LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2015 >> Compass Limited, FWD, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Rear Driveline Module) >> Seal, Output Flange >> Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Seal, Output Flange: Installation: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Seal Onto Installer
GC0083901Courtesy of CHRYSLER GROUP, LLC
  1. Place the seal on the installer.
    Fig 2: Installing Pinion Side Seal
    GC0083902Courtesy of CHRYSLER GROUP, LLC
  2. Install the pinion side seal using Installer (special tool #9893, Installer, Seal) and Handle (special tool #C-4171, Driver Handle, Universal).
  3. Install right side halfshaft. Refer to INSTALLATION .
    Fig 3: Seal Onto Installer
    GC0083901Courtesy of CHRYSLER GROUP, LLC
  4. Place the seal on the installer.
    Fig 4: Installing Ring Gear Side Seal
    GC0083903Courtesy of CHRYSLER GROUP, LLC
  5. Install the ring gear side seal using Installer (special tool #9893, Installer, Seal) and Handle (special tool #C-4171, Driver Handle, Universal).
  6. Install left side halfshaft. Refer to INSTALLATION .
  7. Fill RDA as needed. Refer to STANDARD PROCEDURE .
  8. Lower vehicle and road test.
scientia non olet · About LEMON Manuals