Module, Active Damping Control: Installation: Installation

Fig 1: Air Suspension Control, Blind Spot & Drive Train Control Modules

Courtesy of CHRYSLER GROUP, LLC

1. Slide the Active Damping Control Module (ADCM) (2) into position making sure the latches secure the ADCM.
2. Connect the wire harness connectors to the ADCM (2).
3. From behind/under the LF seat, install the cover panel on the electronic module tub (4).
4. Connect the negative battery cable. Refer to CABLES, BATTERY, INSTALLATION .
5. Perform the ADCM Verification Test.