Sensor, Crankshaft Position: Installation: Installation

Fig 1: Identifying Crankshaft Hub, CKP Electrical Connector, CKP Mounting Bolt & CKP Sensor

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

Before tightening the CKP sensor mounting bolt, be sure the sensor is completely flush to the cylinder block. If the CKP sensor is not flush, damage to the sensor mounting tang may result.

Install Crankshaft Position Sensor (CKP) sensor (4). Tighten bolt (3) to 11 N.m (97 in. lbs.).
Connect CKP wire harness connector (2).
Position CKP access cover. Install bolts and tighten to 15 N.m (133 in. lbs.).
Lower the vehicle.
Connect the negative battery cable.