Sensor, Crankshaft Position: Removal: Removal

Fig 1: Electrical Connector

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Disconnect the electrical connector (1) from the crankshaft position (CKP) sensor.

Fig 2: Sensor Mounting Bolt & Sensor
Courtesy of CHRYSLER GROUP, LLC
Remove the sensor mounting bolt (2).
Carefully twist the sensor (1) from the cylinder block.

Fig 3: O-Ring
Courtesy of CHRYSLER GROUP, LLC
The CKP sensor O-ring (1) can be reused if not damaged.