TPMS Sensors

NOTE: A new sensor ID can be programmed directly into the RF Hub by using a RKE-TPM Analyzer in conjunction with a Scan Tool. Once the new sensor ID has been programmed, the RKE-TPM Analyzer can be used to update the TPM System by activating the sensor.

When a sensor is installed in a tire on the vehicle, the RF-Hub can automatically identify the sensor and its location during the first ensuing drive cycle. Identification will take approximately 10 minutes but the speed of the vehicle must exceed 15 mph (24 km/h). The TPM-RKE 9936 analyzer can also be used to program the new sensor identification number in the RF-Hub module. Scan each TPM sensor at each road wheel, and store each Sensor ID in the correct location. (Left Front, Left Rear, Right Front, Right Rear) Connect the TPM-RKE Analyzer Tool to the Scan Tool. Then follow the programming steps outlined in the diagnostic Scan Tool for "Program Tire Pressure Sensor ID w/ TPM Tool".

NOTE: The sensor IDs can also be programmed using a Scan Tool. Scan each TPM sensor at each road wheel, and store each Sensor ID in the correct location: Left Front, Left Rear, Right Front, Right Rear. Connect the Scan Tool. Then follow the programming steps outlined in the Scan Tool.