Removal And Installation: Installation
WARNING: This page is about a different car, the 2019 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Two blind spot modules are used in this vehicle, one for the left side and one for the right side. Each blind spot module is integral to the blind spot sensor on the same side of the vehicle. Refer to SENSOR, BLIND SPOT, REMOVAL AND INSTALLATION .
NOTE:
If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.