Relay, Power Control: Removal
WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the Power Control Relay (PCR) cover (1).
- Disconnect the wire harness connector (2) from the PCR.
- Remove two nuts (3) and remove the eyelet terminals (1) from the PCR.
- Remove the two nuts that secure PCR (2) to the PCR bracket (1) and remove from the vehicle.