Torque Specifications
TORQUE SPECIFICATIONS
| DESCRIPTION | N. m | Ft. Lbs. | In. Lbs. | COMMENTS |
|---|---|---|---|---|
| Crossmember to Body Bolt | 48 | 35 | - | |
| Crossmember to Transmission Mount Bolt | 47 | 35 | - | |
| Engine to Bellhousing Bolts | 50 | 37 | - | |
| Structural Cover Bolts | 54 | 40 | - | |
| Extension Housing to Transmission Bolts | 27 | 20 | - | |
| Manual Park Release Cable to Case Bolt | 25 | 18 | - | |
| Manual Park Release Cable Bracket to Case Bolt | 25 | 18 | - | |
| Manual Park Release Lever Shaft Nut | 15 | 11 | - | |
| Manual Park Release Lever Assembly Nut | 10 | - | 89 | |
| Oil Pan Drain Plug | 9 | - | 80 | |
| Oil fill Plug | 35 | 26 | - | |
| Transmission Oil Pan Bolts | 10 | - | 89 | |
| Oil Pump Assembly To Case Bolts | Specific bolts need to be pre-tightened. Refer to PUMP, TRANSMISSION OIL, INSTALLATION . | If removed, NEW fasteners must be installed and tightened to specifications. | ||
| Oil Pump Housing To Cover Bolts | 5 + 45° | - | 44 + 45° | If removed, NEW fasteners must be installed and tightened to specifications. |
| Output Speed Sensor Bolt | 8 | - | 71 | |
| Torque Converter Bolts | 42 | 31 | - | |
| Park Pawl Lock Rod Guide Plate Bolt | 10 | - | 89 | |
| Park Pawl Shaft Plug | 35 | 26 | - | |
| Driveshaft Flange Nut | 60 | 44 | - | If removed, NEW fasteners must be installed and tightened to specifications. |
| Shifter Assembly Bolts | 8 | - | 71 | |
| Shifter Knob Lower Shroud Bolt | 7 | - | 65 | |
| Torque Converter to Flexplate Bolts | 42 | 31 | - | |
| Transfer Case to Transmission Nut | 27 | 20 | - | |
| Transmission Isolator to Rear Trans Mount 2wd | 61 | 45 | - | |
| Transmission Isolator to Rear Trans Mount 4wd | 23 | 17 | - | |
| Transmission Mount to Adapter | 33 | 24 | - | |
| Valve Body Bolts | 8 | - | 71 | |
| Wiring Harness Bracket to Transmission | 10 | - | 89 | |