Insulator, Engine Mount, Front: Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Left side shown, right side similar.

If removed, position the engine mount to engine block mounting brackets, install the retaining bolts and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown, right side similar.
Position the engine mounts (2), Install the retainers (1) and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS .
Lower the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Lower the Engine Support Fixture (special tool #8534C, Fixture, Driveline Support) (3) until the engine mounts are seated in the engine cradle.
Remove the Engine Lift Fixture (special tool #8984C, Fixture, Engine Lifting) (1), Engine Lift Adapter (special tool #8984-UPD, Adapter, Engine Lift) (2) and the Engine Support Fixture (special tool #8534C, Fixture, Driveline Support)

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Left side shown, right side similar.
Position the engine mount to the frame.
Install left/right engine mount lower retaining bolts (1) and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS .
Position left/right engine mount heat shields (3), install the retaining nuts (2) and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS .
If the right side engine mount was removed. Install the generator. Refer to 6.4L .
Install the intake manifold. Refer to MANIFOLD, INTAKE, INSTALLATION .
Raise and support the vehicle.
Install the A/C compressor. Refer to COMPRESSOR, A/C, INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Position the belly pan and install the belly pan retainers (1).
Lower the vehicle.
Install the accessory drive belt. Refer to 5.7L/6.4L .
Position the engine oil dipstick tube, install the retaining nut at the right exhaust manifold.
Install the intake manifold. Refer to MANIFOLD, INTAKE, INSTALLATION .
Connect the negative battery cable.