Steering System: Gear: Installation: Installation

NOTE:

Transfer the tie rod ends if they are being reused.

NOTE:

If removed, install the power transfer unit Refer to INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC

Position the dash seal (2) to the steering gear, then install and tighten the dash seal bolt (1).

Courtesy of CHRYSLER GROUP, LLC
Position the heat shield (2) to the steering gear, then install the steering gear heat shield bolts (1) and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC
Position the steering gear to the crossmember.
Install the steering gear mounting bolts (1) and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS .
Install the front suspension crossmember. Refer to CROSSMEMBER, REAR SUSPENSION, INSTALLATION .
If a NEW steering gear is installed, the Electric Power Steering (EPS) learn procedure is required. Refer to EPS LEARN PROCEDURE .