Transmission Verification Test

Perform the following procedure to verify proper Transmission operation after repairs have been performed.

1. SHIFT CABLE ADJUSTMENT 

   Did the repair include replacement of the shifter, shift cable, Transmission Range Switch (TRS) or the transmission assembly?

   Yes 

   • Adjust the shift cable in accordance with the Service Information. Refer to SHIFT CABLE ADJUSTMENT .

   No 

   • Go To  2
2. TRANSMISSION RANGE SWITCH ADJUSTMENT 

   Did the repair include disturbing or replacement of the Transmission Range Switch (TRS)?

   Yes 

   • Adjust the TRS in accordance with the Service Information. Refer to TRANSMISSION RANGE SENSOR (TRS) ADJUSTMENT .

   No 

   • Go To  3
3. VERIFICATION TEST 
   1. Perform the following after completion of a diagnostic repair:
      1. Reconnect any disconnected components.
      2. Connect the scan tool to the Data Link Connector (DLC).
      3. With the scan tool, erase all Transmission and Engine DTCs.
      4. Check the Transmission fluid level and adjust if necessary. Refer to the Service Information for the Fluid Fill procedure.
      5. If the repair include replacing of a solenoid(s), valve body, TCM or transmission assembly, perform the Drive Learn procedure in accordance with the Service Information. Refer to DRIVE LEARN .
      6. Road test the vehicle allowing the vehicle to shift through all gears.
      7. Check for DTCs during and after the road test.

      Were there any Diagnostic Trouble Codes (DTCs) set during the road test?

      Yes 

      • Refer to DTC INDEX (1 OF 2) and/or DTC INDEX (2 OF 2) and perform the appropriate diagnostic procedure.

      No 

      • Repair is complete.