LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2024 >> Compass Trailhawk >> Repair and Diagnosis >> Engine Performance >> System >> 2.0L - DTCS P06DA To P1188 >> DTC Troubleshooting >> P06EF-Engine Restart Performance >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. CHECK FOR AN ACTIVE DTC 
    1. Turn the ignition on.
    2. With the scan tool, erase DTCs.
    3. Test drive the vehicle in Start/Stop mode. Make several complete stops, and Auto-Restart attempts.
    4. Turn the ignition on.
    5. With the scan tool, read DTCs and record on the repair order.

      Is the DTC active or pending?

      Yes 

      • Go To  2

      No 

  2. CHECK THE FUSES, BATTERY CABLES AND STARTER CONNECTIONS 
    1. Turn the ignition off.
    2. Inspect the Fuses, Battery Cables, Posts and Starter Motor connections for signs of corrosion or a poor connection.

      Were the Fuses, Battery Cables and Starter connections in good condition?

      Yes 

      • Go To  3

      No 

      • Repair the Battery or Starter connections in accordance with the Service Information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  3. CHECK THE BATTERY CONDITION 
    1. Use the (special tool #GR8-1220KIT-CHRY, AGM Battery Tester/Charger Station) or equivalent to load test the Battery.
      GC0214656Courtesy of CHRYSLER GROUP, LLC
    2. Using the Midtronics Battery Charger/Tester, check the condition of the Battery.

      Did the Battery pass the test?

      Yes 

      • Go To  4

      No 

      • Replace the Battery in accordance with the Service Information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  4. CHECK THE FUEL DELIVERY SYSTEM FOR PROPER OPERATION 
    1. Perform the CHECKING THE FUEL DELIVERY SYSTEM diagnostic procedure. Refer to CHECKING THE FUEL DELIVERY SYSTEM (HARD START) .

      Were any problems found?

      Yes 

      • Repair the Fuel Delivery System in accordance with the Service Information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .

      No 

      • Go To  5
  5. CHECK THE ENGINE MECHANICAL CONDITION 
    1. Perform the CHECKING THE ENGINE MECHANICAL CONDITION diagnostic procedure. Refer to CHECKING THE ENGINE MECHANICAL SYSTEM . Anything that can cause an intermittent no start condition can cause this DTC to set.

      Were any problems found?

      Yes 

      • Repair the Engine mechanical condition in accordance with the Service Information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .

      No 

      • Replace the Starter Motor in accordance with the Service Information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .