Third Row Seat Belts And Buckles
| Refer to COMPONENT INDEX . |
Third row seating, only available in certain markets, employs middle D-pillar mounted inertia latch-type emergency locking retractors, fixed position upper D-pillar mounted turning loops and fixed lower seat belt anchors secured to the rear D-pillar lower reinforcement. The third row seat belt buckles are secured to the third row seat, center floor mount. All rear seat belts have fixed end-release seat belt buckles.
The seat belt retractors used in all seating positions include an inertia-type, emergency locking mechanism as standard equipment.
The standard inertia-type emergency locking retractor will allow the seat belt webbing to unwind from and wind to the retractor spool freely unless, and until, a predetermined inertia load is sensed. The retractor has an internal inertia latch mechanism that will lock the retractor spool once the predetermined inertia load is sensed. Locking the retractor spool prevents the seat belt webbing from being extracted from the retractor and firmly restrains the occupant wearing the seat belt. The retractor spool is automatically unlatched once the loading of the retractor inertia mechanism and the seat belt are relieved.
The emergency locking mechanism, the retractor tensioning mechanism and the load limiting feature are each integral to the retractor unit and are concealed beneath molded plastic covers located on each side of the retractor spool. These features cannot be adjusted or repaired and if ineffective, damaged or deployed, the entire seat belt and retractor unit must be replaced.