Removal And Installation

REMOVAL

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the driver air bag. Refer to DRIVER AIR BAG, REMOVAL AND INSTALLATION .
Using a trim stick or equivalent, release the retainers on the back of the speed control switches (1) from the steering wheel (3).

Courtesy of CHRYSLER GROUP, LLC
Disconnect the wire harness connector (2) from the speed control switches (1) and remove from the steering wheel (3).
If necessary, remove the fasteners (2) and separate the speed control switches (1) from the switch bracket (3).

Courtesy of CHRYSLER GROUP, LLC

INSTALLATION

If removed, position the speed control switches (1) to the bracket (3). Install the fasteners (2) and tighten securely.

Courtesy of CHRYSLER GROUP, LLC
Connect the wire harness connector (2) to the speed control switches (1).

Courtesy of CHRYSLER GROUP, LLC
Install the speed control switches (1) into the steering wheel (3), pressing firmly to verify the cleats are fully engage.
Install the driver air bag. Refer to DRIVER AIR BAG, REMOVAL AND INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.