Brake Switch (Cruise Control): Service and Repair

Brake Pedal Switch
Removal
1. Disconnect the brake pedal switch electrical connector.
2. Remove the forward locknut.
3. Remove the brake pedal switch from its bracket.

Installation
1. Install one locknut onto the threaded portion of the brake pedal switch and then insert the switch into its bracket.
2. Install the second locknut on. Position the switch in the bracket so that its tip just touches the brake pedal.
3. Install the first locknut up to the bracket and then back off one-half turn. Tighten the second locknut.

Tightening torque: 21 in-lb (29 N.m).

4. Connect the electrical connector.