LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2007 >> Rio Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Abs (Anti-Lock Brake System)) >> Diagnostic Trouble Code Chart(DTC) >> DTC C1513 Brake Switch Error >> Monitor SCANTOOL Data
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Monitor SCANTOOL Data

WARNING: This page is about a different car, the 2007 Kia Sedona and 2006 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect scantool to Data Link Connector(DLC).
  2. Ignition "ON" & Engine "ON"
  3. Press the brake pedal.
  4. Monitor the "STOP LAMP SWITCH" parameter on the scantool.

    Specification: Lateral G sensor: ± 0 G, YAW rate Sensor: ± 0 deg/s

    Fig 1: Scan Tool Display - EBD Warning Lamp
    G04883886Courtesy of KIA MOTORS AMERICA, INC.
  5. Whenever brake pedal is pushed down, is the brake switch's scantool data changed ON/OFF?

    YES 

    • Fault is intermittent caused by poor connection in Yaw Rate & Lateral G sensor harness and/or HECU's connector or was repaired and HECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination.

    NO 

scientia non olet · About LEMON Manuals