LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2007 >> Rondo Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> DTC Troubleshooting Procedures (2 Of 2) - 2.4L >> DTC P0451 EVAP. Emission System-Pressure Sensor Range / Performance >> Verification Of Vehicle Repair
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Verification Of Vehicle Repair

  1. Reconnect all EVAP hardware that was previously disconnected
  2. Start engine to normal operating temperature
    NOTE: Evaporative Emissions Systems (EVAP) Leak Tests can be run by the Scan Tool. The tests are automated and provide either a pass-fail result or directions to check for DTCs.
  3. Install scan tool and clear DTC
  4. Perform "EVAP. LEAKAGE TEST" mode referring to enable conditions as below
    NOTE: EVAP. Leakage Test enable conditions
    • Following conditions must be fulfilled to start the test.
      1. Engine warm up at Idle Status
      2. No relevant DTC
      3. Fuel level is below 80%
  5. Monitoring for (pending) DTC. Is the same DTC set?

    YES 

    • Go to the applicable troubleshooting procedure.

    NO 

    • System performing to specification at this time.
scientia non olet · About LEMON Manuals