DTC C2380 Abs/TCS/ESC Valve Error: DTC Detecting Condition
DTC DETECTION CONDITION AND POSSIBLE CAUSE
| Item |
Detecting Condition |
Possible cause |
| DTC Strategy |
|
|
| Detect Mode |
- Initial Check
- Outside the ABS control cycle
- Inside the ABS control cycle
- Diagnosis mode
- Failure mode
|
| Enable Conditions |
- If the valve relay is switched ON and corresponding solenoid driver OFF and the voltage of solenoid < 3.5 ± 0.5V continuously for 56ms, the failure is detected.
- If the valve relay is switched ON and corresponding solenoid driver ON and the voltage of solenoid > 1.5 ± 0.5V continuously for 56ms, the failure is detected.
|
| Fail Safe |
- System down. The ABS/EBD/ESC functions are inhibited.
- The valve relay and all solenoids are prevented from being switched on.
- The ABS/EBD/ESC warning lamps are activated.
|