DTC P0708 Transaxle Range Switch - High Input: DTC Detecting Condition

WARNING: This page is about a different car, the 2007 Kia Optima, 2007 Kia Magentis, 2006 Kia Optima, and 2006 Kia Magentis. However, it is still accessible from the selected car via links, so may be relevant.

DTC CHART

Item	Detecting Condition	Possible cause
DTC Strategy	Check for multiful signals	Open or short in TRANSAXLE RANGE SWITCH Faulty Shift cable adjustment Faulty inhibitor switch and Manual control lever position adjustment Faulty TRANSAXLE RANGE SWITCH Faulty PCM
Enable Conditions	Engine state = "RUN" 11V ≤ Battery Voltage ≤ 16V TPS ≥ 3%
Threshold value	Multiple signal
Diagnostic Time	More than 30sec
Fail Safe	Recognition as previous signal When signal is input "D" and "N" at the same time, TCM regards it as "N" RANGE After PCM/TCM Reset, If the if the PCM/TCM detects multiple signal or no signal, then it holds the 3rd gear position