LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2010 >> Rondo EX, 2.7 6 >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System Diagnosis (3 Of 3) - 2.7L >> DTC P0604: Internal Control Module Random Access Memory (RAM) Error >> Scantool Diagnostics >> Monitor DTC Status
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Monitor DTC Status

  1. Check DTC Status
    1. Connect scantool to Data Link Connector (DLC).
    2. IG "ON".
    3. Select "Diagnostic Trouble Codes (DTCs)" mode, and then Press F5 (INFO) to check DTC's information from the menu
    4. Read "DTC Status" parameter.
      Fig 1: Scantool Display - DTC Status Parameter
      G06489386Courtesy of KIA MOTORS AMERICA, INC.
    5. Is parameter displayed "Present fault"?

      YES

      1. Go to "TERMINAL AND CONNECTOR INSPECTION " procedure.

      NO

      1. Fault is intermittent, caused by poor contact in the sensor's and/or PCM's connector, or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary, then go to "VERIFICATION OF VEHICLE REPAIR " procedure
scientia non olet · About LEMON Manuals