Component Inspection

Visual Check
1. IG KEY "OFF".
2. Disconnect HO2S (S2) connector.
3. Check if HO2S (S2) is contaminated or damaged by foreign materials.
4. Has a problem been found?
  YES
  
  Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage. Check for poor connections, and check the related circuit between ECM and component thoroughly. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  
  NO
  
  Substitute with a known-good HO2S (S2) and check for proper operation.
  
  If the problem is corrected, replace HO2S (S2) and go to "VERIFICATION OF VEHICLE REPAIR " procedure.