Repair Procedures: Installation
WARNING: This page is about a different car, the 2011 Hyundai Veracruz. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
- Install the new Front Impact Sensor.
- Tighten the Front Impact Sensor mounting bolt.
Tightening torque:
: 6.8 ~ 9.2 N.m (0.7 ~ 0.9 kgf.m, 5.0 ~ 6.8 lb-ft)
- Connect the Front Impact Sensor connector.
- Reconnect the battery negative cable.
- After installing the Front Impact Sensor, confirm proper system operation: Turn the ignition switch ON the SRS indicator light should be turned on for about six seconds and then go off.