Repair Procedures: Removal

WARNING: This page is about a different car, the 2014 Kia Forte5 and 2014 Kia Forte Koup. However, it is still accessible from the selected car via links, so may be relevant.

Remove the valve body assembly.
(Refer to "VALVE BODY ")
Disconnect the input & output speed sensor connector (A).
Loosen the main connector bolt (B).
Tightening torque:

(B) 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 1: Input And Output Speed Sensor Connector & Bolt
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the solenoid valve connector (A).

Fig 2: Solenoid Valve Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the solenoid valve connector after removing a clip (A).
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 3: Removing Solenoid Valve Connector
Courtesy of KIA MOTORS AMERICA, INC.