Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the resonator and the air intake hose (Refer to "INTAKE & EXHAUST SYSTEM ").
Disconnect the ETC module connector (A).

Fig 1: ETC Module Connector
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the coolant hoses (B).
Remove the installation bolts (C), and then remove the ETC module from the engine.

Fig 2: Coolant Hoses & Installation Bolts
Courtesy of KIA MOTORS AMERICA, INC.